-
Development, Fabrication And Performance Evaluation Of A Single Wheel Driven Boom Sprayer
-
-
-
2.8 Types of Pump for Spraying
According to Fraser F (1979), spraying pumps are classified as follows
I. Roller Pumps: This is the most popular pump used by farmers world-wide. The seal and roller materials should be selected based on their compatibilities with the pesticides.
plate 2.4: Roller pump
I. Diaphragm Pumps These compact pumps are popular for use with abrasive and corrosive pesticides. There oil-filled piston chambers protect the pump materials.
-
-
-
ABSRACT - [ Total Page(s): 1 ]ABSTRACTThe single wheel driven boom sprayer was developed, fabricated and evaluated for its performance at the department of Agricultural and Bio-environmental engineering workshop, Kwara state polytechnic, Ilorin. The spraying performance was carried out at spraying height of 0.5m, 0.6m and 0.7m respectively. The theoretical field capacity CT, the effective field capacity CE and Field efficiency (Å‹) at spraying height of 0.5m are 0.285ha/hr , 0.165ha/hr and 58%, while at spraying hei ... Continue reading---
LIST OF TABLES - [ Total Page(s): 1 ]LIST OF TABLES TABLE   4.2.1      Spraying parameters at spraying height 0.5m     4.2.2      Spraying parameters at spraying height 0.6m         4.2.3      Spraying parameters at spraying height 0.7m    4.2.4      Average spraying data at spray height 0.5,0.6      and 0.7                                   ... Continue reading---
LIST OF PLATES - [ Total Page(s): 1 ]LIST OF PLATES   PLATES          2.1         Hydraulic energy sprayers      2.2         Gasoline energy sprayers     2.3         Centrifugal energy sprayers      2.4         Roller pump     2.5         Diaphragm pump     2.6         Piston pump        2.7         Turbine pump      3.1         Knapsack sprayer      3.2  ... Continue reading---
TABLE OF CONTENTS - [ Total Page(s): 1 ]TABLE OF CONTENTS      Title page        Certification       Dedication       Acknowledgements        Abstract       Table of content        List of Tables        List of Plates CHAPTER ONE   1   Introduction    1.2   Statement of the problem    1.3   Objective of the project    1.4   Justification of the project  CHAPTER TWO   2   Literature review    2.1    ... Continue reading---
CHAPTER ONE - [ Total Page(s): 2 ]CHAPTER ONE1.0   IntroductionCrop yield is reduced by mainly due to attack of pest, diseases and weeds. Chemical control is the popular method adopted for controlling most insects, weed and diseases. The chemical are applied either by spraying or dusting. Spraying is one of the most effective and efficient techniques for applying small volume of spray liquid to protect crops. In conventional methods, manually operated low and high volume hydraulic sprayer and power operated hydraulic s ... Continue reading---
CHAPTER THREE - [ Total Page(s): 5 ]CHAPTER FOUR4.0   Performance evaluation of the Single wheel driven boom spryer4.1      Experimental procedure   An area of land was selected for carrying out the performance evaluation of the sprayer, the area of land was beside the automotive workshop in the Institute of Technology, Kwara state polytechnic. The area measured 20m by 6m which was divided into three subplots. The tank of the sprayer was filled with water and then pulled to start spraying from the beginning to the e ... Continue reading---
CHAPTER FOUR - [ Total Page(s): 5 ]average time =24.24s   Speed = distance/time m/sSpeed= 0.02/0.00631 = 2.972km/hrWidth (W )= 0.9mTheoretical field capacity (CT) = SW/10Theoretical field capacity (CT) = (2.972 ×0.9)/10 = 0.267 ha/hrEffective field capacity CE = SWE/10Effective field capacity CE = (2.972 ×0.9 ×o.58)/10 = 0.155ha/hrField efficiency Å‹ = CE/CT=         0.155/0.267=58.05%   ... Continue reading---
CHAPTER FIVE - [ Total Page(s): 1 ]CHAPTER FIVE5.0   Conclusion and Recommendation 5.1   Conclusion The single wheel driven boom sprayer was developed, fabricated and evaluated for its performance at the department of Agricultural and Bio-environmental engineering workshop, Kwara state polytechnic, Ilorin.. The spraying performance was carried out at spraying height of 0.5m, 0.6m and 0.7m respectively. The theoretical field capacity CT, the effective field capacity CE and Field efficiency (Å‹) at spraying height of ... Continue reading---
REFRENCES - [ Total Page(s): 1 ]REFERENCESAlam, M., and D. Hussain. 2010. Variability of Lever Operated sprayer. Paper acceptedin AMA. 28(2): 11-13Alam, M., M. A. Bell, and A. M. Mortimer. 2000. Targeting farmer sprayapplications for improved safety and uniformity. Int. Rice Res. Conf. IRRI. Phillipines.:223.FAO. 1998. Agriculture pesticides sprayers. Vol. 2. FAO technical standards: sprayer specifications and test procedures.:7-8.Fraser, F. and L. C. Burrill. 1979. Knapsack sprayers:21-25.Friedrich, T. 1997. Approach to imr ... Continue reading---
-
ABSRACT - [ Total Page(s): 1 ]ABSTRACTThe single wheel driven boom sprayer was developed, fabricated and evaluated for its performance at the department of Agricultural and Bio-environmental engineering workshop, Kwara state polytechnic, Ilorin. The spraying performance was carried out at spraying height of 0.5m, 0.6m and 0.7m respectively. The theoretical field capacity CT, the effective field capacity CE and Field efficiency (Å‹) at spraying height of 0.5m are 0.285ha/hr , 0.165ha/hr and 58%, while at spraying hei ... Continue reading---