• The Effect Of Water/cement Ratio On Compressive Strength Of Palm Kernel Shell Concrete At 1:2:4 Nominal Mix

  • CHAPTER FOUR -- [Total Page(s) 6]

    Page 5 of 6

    Previous   1 2 3 4 5 6    Next
  • CHAPTER FOUR -- [Total Page(s) 6]

    Page 5 of 6

    Previous   1 2 3 4 5 6    Next
    • ABSRACT - [ Total Page(s): 1 ]ABSTRACT IS COMING SOON ... Continue reading---

         

      APPENDIX A - [ Total Page(s): 2 ] ... Continue reading---

         

      CHAPTER ONE - [ Total Page(s): 3 ]CHAPTER ONE1.0    INTRODUCTION    Concrete is a composite engineering material made from the mixtures of cement, water, fine aggregate (sand), coarse aggregates (such as crushed stones or rocks and granite) and a small amount of air in a specific proportion that hardens to a strong bony substance  or become ossified. The cement always serves as a binder for the aggregate.The uniqueness quality of concrete makes it desirable as a building material, because it can be moulded into virtually ... Continue reading---

         

      CHAPTER TWO - [ Total Page(s): 4 ]The water to cement ratio, or w/c ratio, largely determines the strength and durability of the concrete when it is cured properly. The w/c ratio refers to the ratio of the weights of water and cement used in the concrete mix. A w/c ratio of 0.4 means that for every 100 lbs of cement used in the concrete, 40 lbs of water is added. For ordinary concrete (sidewalks and driveways), a w/c ratio of 0.6 to 0.7 is considered normal. A lower w/c ratio of 0.4 is generally specified if a higher quality con ... Continue reading---

         

      CHAPTER THREE - [ Total Page(s): 3 ]CHAPTER THREE3.0    METHODOLOGYFor better achievement of this project, the following stages are ensured:    COLLECTION OF MATERIALS    The materials comprises of cement, sand, palm kernel shell and water. Palm kernel shell was obtained from a local palm kernel producing village Oko, Irepodun LGA, Kwara State Nigeria.    PREPARATION OF PALM KERNEL SHELL (PKS)Due to high water absorption of palm kernel shells, it is mandatory to soak the aggregate for about 30 minutes. It i ... Continue reading---

         

      CHAPTER FIVE - [ Total Page(s): 1 ]CHAPTER FIVE5.0    CONCLUSION AND RECOMMENDATION5.1    CONCLUSIONi.    The result of the physical properties obtained show that PKS can be used as partial or complete aggregate substitution for lightweight structural concrete at 1:2:4 nominal mix.ii.    The compression strength increases with advancement of age but decreases with increase in water cement ratios. That is, at w/c ratio of 0.3 the compressive strength is 6.5N/mm2 at 28 days while at w/c ratio of 0.5, it is 3.99N/mm2 at ... Continue reading---

         

      REFRENCES - [ Total Page(s): 1 ]REFERENCENeville, A.M. (1996). “Properties of Concrete”. Longman Group Limited, London.Okafor, F.O. (1988). “Palm Kernel Shell as Aggregate for Concrete”. Cement Concrete Research Vol. 18, No 6, pp. 901-910.Okpala, D.C. (1990). “Palm Kernel Shell as a Lightweight Aggregate in concrete”. Building  and Environment 25, pp. 291-296Olanipekun, E.A., Oluola, K.O., and Ata, O. (2006). “A comparative Study of Concrete Properties Using Coconut Shell and Palm Ker ... Continue reading---