-
Radio Frequency Based Wireless Batch Counting Device For Brewery
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
-
1.4. Significance of the Project
This project work
signifies a lot in telecom, computer and electronic engineering it is
very useful in a number of domestic places like in bedroom and security
lamps in the compound. A project of this type if modified can be used
as a gate/door opening system, car immobilizer and for industrial
process control. Another vital significance of this system is in the
control of Air conditioner and refrigerators and other lamps in modern
buildings. This system can be used to start and stop a power generating
set from a distance.
1.5. Scope of the Project
This
project work covers the following; Tuned Radio-frequency transmitter and
receiver modules, Ne555 timer, Decimal counting unit, Decoders and
transistors and electromagnetic relay. It also lays great emphasis on
passive and active components used to implement the system. It also
x-rays the mode of calculations of the basic parameters used in the
design and other areas of application of the device. This report
elaborates on the block diagram and principle of operation of the
system.
1.6. Limitations
1. This project work is focused on the design and implementation of Rf batch counter for brewery.
2. It is a prototype of the real-life system due to the ratings of the components used to implement it.
3. It can only count products in an opaque bottle? (Filled or partially filled)
4. It uses only Radio frequency to communicate with the receiver
5. The system is powered using power from MAINS.
6. The receiver displays a maximum of 100 counts (00-99) and does not contain a memory device for storage of data.
1.7. Project Report Organization
This
project report is presented in six chapters to appropriately illustrate
the steps involved in its implementation. Chapter one introduce the
design overview, objectives and significance of the project. Chapter
two is basically the literature review and some theories relevant to the
design. Chapter three is on the system design analysis while chapter
four elaborates on the implementation, testing and result. Finally
chapter five summarizes the entire thesis and recommendations.
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
ABSRACT - [ Total Page(s): 1 ]This project work deals on the design and implementation of a Rf based wireless batch counting device for brewery capable of counting the bottled products in the conveyor and displaying the value numerically and wirelessly to its receiver installed about 100 meters away. This project is realized in two functional units: the transmitter and receiver units. The transmitter unit is installed in the conveyor while the receiver unit is installed at a remote location. They interact by the principl ... Continue reading---
