-
Design And Construction Of A Solar Powered Multiple Cell Phones Charging Booth
CHAPTER ONE -- [Total Page(s) 4]
Page 4 of 4
-
-
-
At
present all the gadgets are charged typically with a 5V to 5.5V source
(current could vary depending upon the capacity of the battery,
typically limited to 500mA). Hence for charging the voltage provided to
the gadgets should not be higher than the above mentioned voltage range.
1.6 Thesis Outline
This
thesis consists of five chapters. Chapter One will discuss about the
overview of the project, objective of the project, project scope and
problem statement.
Chapter Two contains a detail description of the
original setup. It explains about the concept used and the components
that involved in the project.
Chapter Three includes the original
designed circuit and its components. Also a complete analysis to the
presented design will be given.
Chapter Four shows the experimental work and the practical testing results to the constructed circuit will be explained.
The
last Chapter contains the detail description about conclusion and
recommendation. It concludes the whole project and gives a future
recommendation to make this project perfect.Also it explains the
important merit of the project.
CHAPTER ONE -- [Total Page(s) 4]
Page 4 of 4
-
-
ABSRACT - [ Total Page(s): 1 ]Cell phones need electric sources to charge their batteries in order to work, but there are people in developing and third world countries that find it hard to access electric sources.In an attempt to provide an alternative means of charging to those unfortunate areas in third world and developing countries, a solar powered cellphone charging booth is to be designed and constructed in this project.The goal of this project is to create a multiple output solar cell phone chargers for Local areas t ... Continue reading---
