-
Construction And Design Of 1.5kva Inverter
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
-
1.2. Basics of the project:
In this document one can understand the very basics of electronic
Components,
PCB designing, the software Proteus and all the questions which one may
come across while doing sonic electronics project for the first time.
This abstract contains information about the software Proteus, right
from its manufacturer the Lab-center Electronics to the key components
used in the design procedure for the inverter circuit. It also includes
the problems which the circuit may have to face if there is some kind of
distortion in the applied input or some voltage fluctuations may also
occur as result of improper power supply and the project deals with all
these problems.
One can also know about voltages and currents
flowing through each component in the circuit as per the mathematical
calculations done in the record. The abbreviations included in the
record are easy to understand and are explained in detail at the end of
chapter 04 with all their long forms. The reference in the same chapter
will help the reader to go to the particular sites and will help the
reader to clear his)her doubts, if any. Chapter 03 includes analysis of
the mini-project which will help him understand about the circuit of
inverter that how it works, the basic ideology used in the designing of
circuit. One would be able to understand about why a particular
component of particular ratings only is used in the circuit in this
chapter. The same chapter also includes the circuit diagram of simple
100w inverter along with the ratings of the components.
We will also
come across Proteus Virtual System Modeling (VSM which combines mixed
mode SPICE circuit simulation, animated components and microprocessor
models to facilitate co-simulation of complete microcontroller based
designs. As an abstract one can say that the overall project helps to
learn about the smallest component in detail. A person who is very much
unknown to these components will get the basic idea as well as a little
bit of deep idea for example about the polarities of the components
used, which capacitors require to he connected in correct polarity and
which no. how much power or current is required for LEDs which is a
light activated device.
1.3 Block diagram and its description:
The
block diagram of simple 100w inverter consists of a battery which is
the power source for the entire circuit. In the block diagram battery
supply is given to the MOSFET driver where it will convert DC to AC and
the resulting AC is given to the step up transformer from the step up
transformer we will get the original voltage.....
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
