-
Construction Of A Microcontroller Based
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
-
1.4 DEFINITION OF TERMS Voltage regulation: this is simply, the control
of voltage as needed by the design. Voltage regulation ensures that a
specific and steady voltage supply is provided for the system operation.
Electromagnetic switch: this is the contact making that exists between
terminal of electronic components. These switches are carried through a
process known as electromagnetic induction. Examples of devices that can
perform this action is the relay. Erasable programmable read only
memory (EPROM): this is a type of memory device which can be programmed.
The device also has program erasing ability if it is to be
reprogrammed.
1.5 PROJECT REPORT ORGANIZATION
Five chapters were
covered in the course of design and development of this project. The
chapters and their contents are as follows:
Chapter one is the
introductory chapter that gives the background of the project, aim and
objective, the scope and organization of the project.
Chapter Two handles the literature review; information on previous work relevant to the topic.
In
chapter three, I discussed the practical system analysis of the
project. Also discussed is the requirement analysis, which is all the
information, gathered from a wide research on microcontroller over/under
voltage protective system.
Chapter four deals with the design procedure, construction steps, packaging and cost of components.
Chapter five contains the test result, summary, conclusion and recommendations for further work.
CHAPTER ONE -- [Total Page(s) 2]
Page 2 of 2
-
-
ABSRACT - [ Total Page(s): 1 ]Microcontroller based automate controller is a project design of a system that is used in operating a gate automatically. The system opens the gate automatically when a human being or car is about to enter a compound or exit a compound. The system works by sensing the light rays from the head lamp of the vehicle. The light ray is sensed and signal is used in operating the gate. Different blocks of circuit are put together to ensure that the system works perfectly as desired. The blocks include; ... Continue reading---
