-
DESIGN AND CONSTRUCTION OF AN AUTOMATIC BATTERY CHARGER USING THYRISTOR (SCR)
-
You can get the complete material / full content @ a service support fee of ₦4,800.00(12-USDT) only
-
- Contributor: projectwaka
- engagements: 154
- Case No: 557258ch
- Request PDF:
-
-
ABSRACT - [ Total Page(s): 1 ]This project is titled design and construction of a battery charger using SCR. Automatic battery charger presented here is an acid battery charger that is designed to charge any acid battery using thyristor to supply the required current. This charger will charge any 12V lead acid battery including flooded, gel and AGM. It is fully automatic and will charge at a rate up to about 4A until the battery voltage reaches a preset point at which it will switch to a very low current float charge. If the battery voltage drops again the charger will begin charging until the voltage once again reaches t
... Continue Reading
-
ABSRACT - [ Total Page(s): 1 ]This project is titled design and construction of a battery charger using SCR. Automatic battery charger presented here is an acid battery charger that is designed to charge any acid battery using thyristor to supply the required current. This charger will charge any 12V lead acid battery including flooded, gel and AGM. It is fully automatic and will charge at a rate up to about 4A until the battery voltage reaches a preset point at which it will switch to a very low current float charge. If the battery voltage drops again the charger will begin charging until the voltage once again reaches t
... Continue Reading
-