-
Design And Implementation Of A Wireless Car Security Device System
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
-
The device must be hidden in the part of the car where an
unauthorized person or persons cannot easily reach to it. On the other
hand, for security purpose, the tracking system should be in an area
inside the car where one cannot be able to see or interfere with its
operations.
The car tracking system connection deals with the
mounting and connection of the demobilizer to work with the fuel pump of
the car. The main cable supplying power to the fuel pump is cut off and
attached to relay which will carry-out the demobilizing of the car,
switching off the supply of electrical power to the fuel pump. The
schematic diagram of the connection is shown in chapter three.
1.2 THE AIM AND THE OBJECTIVES OF THE PROJECT
The
aim and the objective of this project are to demonstrate the
application of GSM network and logic gate network in car security
systems. The device is capable of demobilizing a car and also track the
location in which the car is parked or demobilized. It also to acquire a
maximum security or protection of our car to avoid been snatched away
from the owner. With this system you are sure of a quick recovery of
your car as soon as it been stolen.
The logic unit controlled
system is a compact and rugged control unit designed for interface with
standard cellular mobile phone that have GPS (Global Positioning System)
enable and operates by receiving sound call tones from the phone audio
output. Its mains are powered by DC battery and it provides contact
closures capable of switching the hole system. By using a hand set that
has GPS enable is possible at every location within the coverage of the
network mast to track and locate the car.
1.3 SCOPE OF THE PROJECT
1, Highlight on how it works
2, Hardware description
3, Software description
4, Consecration of the hardware and the software of the system (firmware)
1.4 LIMITATIONS OF THE PROJECT
The
working of a car tracking system depends on the communication firm one
is using. So if a car is been demobilized, the owner can only track the
vehicle with the help of the nearest network mast mounted in the area.
For instance, if a car is snatched from ESUT Agbani Campus and it
demobilized at Garriki, If the mast covering Garriki is at Amechi, the
owner can only get a signal from his cell phone showing the location of
the mast when dial the number used for construction of the car security
device installed in that car. From the GPS phone it will be indicated
that the car is located at the point where the mast is sited which is
Amechi. So the owner will bear the responsibility of searching round the
area within the mast network coverage trying to locate the car. Also,
since the device is using signals from a network provider, the car can
only be tracked if it is immobilized within the network area which is
been used in the system.
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
ABSRACT - [ Total Page(s): 1 ]Car security systems are still of no match to the well-equipped thieves. It is just a matter of seconds to break through the system. This project introduces and describes the design of mobile controlled car security system offering higher level of car security features. The mobile controlled car security is capable of providing an effective two-way communications between the alarm system and the car owner. This system is able to notify the car owner immediately when intrusion is detected. Additi ... Continue reading---
