-
The Design And Fabrication Of A Metal Bookshelf
CHAPTER ONE -- [Total Page(s) 2]
Page 1 of 2
-
-
-
CHAPTER ONE
1.1INTRODUCTION
A bookshelf is an invention with partition where books and files are packed on offices, libraries and even homes.
A bookshelf can be wooden, metallic or even glass. They can also be
dismountable and undismountable. In our project, we dedicated to design
and fabricate on undismountable met6allic bookshelves. Certain
advantages were considered before starting off this project. An
undismountable metallic bookshelf, if built with lart and serer its
purpose. Also, lose of parts, 9of many dismountable bookshelf led into
considering one undismountable type.
1.2DESCRIPTION OF THE BOOKSHELF
This description of the bookshelf is as shown in fig. (I) and fig. (2), is made up of the following:
1 The sides
2 The back
3 The partition
4 The frame work.
THE SISDES
The
sides of the bookshelf is as shown in the figure provided (fig2). 8it
is made up of the square pipe frame and mild steel material welded to
it. Each side is specially designed to act as the support in carrying
the load undress any stress. The load displays on the system. The
sides are lent at 90o to each other, giving the system a more rigid
frame work.
The sides measures 1500mm Height, 1200mm Width, 500mm the dept.
CHAPTER ONE -- [Total Page(s) 2]
Page 1 of 2
-
-
ABSRACT - [ Total Page(s): 1 ]Knowledge could only be obtained successfully by the use of book for research but unfortunately because of hard times, books have become very expensive. This is called for presentation of books already purchased whether in the library or on the household so that it can be used by the future generation. There could only be done by stacking books systematically on a book rack where by it can be file from rats and other insects that could blestroy books.Our aim contribution to this development ... Continue reading---
