-
An Electric Pop-corn Machine
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
-
1.0 SPECIFICATION OF THE PROBLEM
1.1 REQUIREMENTS OF THE DESIGN
The design is expected to achieve the following objective
1) Production of popcorn in long scale.
2) Increase the efficiency of producing popcorn
3) Moderate the rotation of the stirrer by using the right motor.
4) To reduce the heat that will be lost by lagging the output.
5) To regulate the voltage used to produce popcorn.
6) Achieve proper utilization of the heat by using a good conduction as the pot e.g. Aluminum.
7) The use of wood as handle to effect easy conveying of the popcorn from the pot.
8) The presence of bulb to enhance production at night.
1.2 CONDITION FOR USE
The machine might be used under elevated temperature.
The machine should be stored after used in a clean and dry place.
Routines cleans would be necessary to avoid rusting of the pot.
The motor should service from time to time to maintain it efficiency.
1.3 CHARACTERISTIC
The
machine should not be too heavy. The machine should not be too big to
enhance effecting stirring. The distance between the pots should not be
too large to reduce heat loss. Aluminum should be used for both the
frame profile and the construction of the stirrer. Glass should be used
to due the case because of the transparency.
CHAPTER ONE -- [Total Page(s) 3]
Page 2 of 3
-
-
ABSRACT - [ Total Page(s): 1 ]An electric popcorn machine is machine that is used to popcorn for human consumption. It uses electricity as it sources of energy, transfer it energy, that is used to pop the Corn. Also it has a stirrer, which rotate due to the convection of electrical energy from the source to mechanical energy in the motor, the stirrer tons the corn so that it will not burns.This project went as far as meeting most of the requirement of advancement in technology, which lead to make-work easy and comfortable fo ... Continue reading---
